G Scale Model Train Forum banner

Question re. Crest Revolution installed in LGB Genesis

1K views 2 replies 2 participants last post by  Jim Agnew 
#1 ·
After installing the Revolution in the engine, I’m getting a strange response when increasing the speed. If the engine is in reverse, the lights come on full brightness at speed step 11, but when I reverse direction, the lights do not reach full brightness until speed step 22. I’m using the existing PCB to connect to the lights and motors. I connected the Revolution by tapping into one set of motor pickups. Any suggestions on the possible cause would be appreciated.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top